Answer / sunil guru

HERE IS THE RIGHT ANSWER......
1.TYPE TEST
2.ROUTINE TEST

OTHER TEST FOLLOWS AS UNDER
1.MEASUREMENT OF STATOR AND ROTOR RESISTANCE
2.NO LOAD TEST
3.OVER LOAD TEST
4.TEMPERATURE RAISE TST
5.HIGH VOL. TST
6.INSULATION RESISTANCE TST
7.FULL LOAD TST
8.REDUCED VOLTAGE RUNNING UP TST
9.LOCKED ROTOR TEST
10.BLOCK ROTOR TEST
11.MOMENTURLY OVER VOLTAGE TEST


IF DISAGREED THEN MAIL ME AT parmar20072008@yahoo.com
I WIL C THAT.............

Answer / arun

There are two type of testing in motor.
1,Insulation Resistance test,
2,winding resistance test

Answer / vithal

apart from IR value and Winding resistance... one should
also measure IR & wdng resi for the Heater if the motor has
a high KW rating.

Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18

0 Answers   TCS,

---

WHY THE +VE POLARITY OF 48V DC POWER SUPPLY IS USUALLY GROUNDED?

1 Answers   Tulip,

---

Tell me all plants load factors i.e which plant operating on which load?

0 Answers   Bhel,

---

what is the solution for meger test failed the MV cable?

1 Answers  

---

we convert 66kv to 33kv then 33kv to 11kv,11kv to 440v.why not we convert directly from 66kv to440v?

7 Answers   HCL, L&T,

---

I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing

0 Answers  

---

why armature is placed in stator but not in rotor in synchronous generator ?

2 Answers   Student,

---

Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?

0 Answers  

---

Power Factor Correction Panel (Manual & Automatic)

0 Answers  

---

Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards

0 Answers  

---

What happens if 25 Hz frequency is applied for 400/200,50 Hz single phase Transformer.Will Voltage increase ?

2 Answers   Bhel, Dawlance, IBM,

---

What is the deference between earth fault & earth leakage

1 Answers  

---