Answer / nur.asidik

knee point voltage is only for protection, not for measurement, it is depend on your protection you need,for example, 87 need higher Vkp than 50/51, just follow your relay requirement. I mean your CT Vkp should higher than Relay required Vkp. refer to IEC, for class 5P or 10P, Vkp is as a function of ALF, Rct, VA, and secondary ratio of CT

why excitor coil of an alternator can fail

3 Answers  

---

How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?

0 Answers  

---

In a simple spur gear train, gears with 24, 48, 32, 72 and 96 teeth are in sequence. The gear with 24 teeth runs at 900 rpm. The speed in rpm of gear with 72 teeth is

1 Answers   Caterpillar,

---

what is LSR?

0 Answers  

---

parallel operation for tansformer which condition fill fil for that

11 Answers   ITC Infotech, Suzlon,

---

how to determine ct ratio in ht vcb?

0 Answers   Techno Engineering,

---

Buchholz relay is used ………. a) protection T/F b) oil T/F c) Air core T/F

8 Answers   Engineers India Limited,

---

Why electrical heaters are not provided with overload relays in circuits

1 Answers  

---

please explain power factor in simple words.....

3 Answers  

---

In a 3 phase,400v,4 wire system, 2 incandescent lamps, one having 230v,100w and the other 230v,200w are connected between r phase- neutral and y phase-neutral respectively. If neutral wire breaks which lamp will fuse first and why?

3 Answers   Eskom, SSC,

---

Difference in load break switch, isolator and circuit breaker.

1 Answers   KSEB, L&T, Siemens,

---

How to identify 3 phases of 3 phase supply irrespective of there color????

1 Answers  

---