Answer / syed shoeb ullah hussaini

first let me tell you about
transformer .. Transformer
work when an alternating
current is given as input ..... So
in the case of dc drive we
need an transformer but we
are have dc as a input ... In this
case we give input to
transformer in pulsating
form ... Means we are give
voltage in the form of pulses
so that transformer will work
but if we give direct d.c then
transformer will burn ...

Answer / shailesh rathod

Transformer working in always AC it is not working in DC.

Answer / manohar

pulse transformer is used to fire the thyristor gate-cathode
as per required.Anode is supplied with voltage & firing will
be done to thyristor as per referrence voltage

Answer / aniruddha

it will give impulse signal at secondary side
in pulse for constant state its o/p is o

Answer / mahantesh

pulse transformer is placed between any two phase. which give feedback to the pulse generator, so depending upon sine waves generate the pulses .then it it generate pulses and feed to thyristor.

i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good

0 Answers  

explain how hunting can be reduced in an alternators?

3 Answers  

At 765Kv, I have seen the use of PT at line side for metering and CVT for protection, although as far as my knowledge is concern, PT at this voltage level will have huge loss and more cost as compared to CVT as CVT can also perform same function of Protection and Metering? So my question is why use PT and not CVT for metering and protection in order to reduce the cost.

1 Answers  

Why neutral cable carry current.

0 Answers   Tech Mahindra,

Between Star-Delta & Star-Star Power transformer which one is efficent for Earth Fault?

10 Answers  

how we can calculate cable size of 230v,1 hp single phase motor ? panel to motor distance is 25 meter

4 Answers  

What is defference between earthed and unearthed cable(HT)? Which is better for under ground cabling?

1 Answers  

How many percent of power are not being registered if we bypass one side of the meter base terminal using #8 cu wire on 1-phase kwhr meter. 

1 Answers  

What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1

0 Answers  

what is first pole to clear factor ?

3 Answers  

What is difference between Earthing, Ground and Neutral?

1 Answers   ABB, ABC, Indo Asian,

What does VVVF stands for in VVVF drive ? How does it differ from VVF drive?

8 Answers   HAL,