Answer / mithilesh kumar

In Yokogawa DCS,
Domain means how much unit are present.
That means if in this plant 100mw x1 then domain
No is 1, if in this plant 100mw x 2 then domain is 2.
this communication done with the help of BCV and
CGW.
Station means how much FCS and HIS
Present for this unit. In yokogawa FCS start
With 01 and HIS start from 63.
so domain and station coding is always together.
It's symbol for eg. Is 0104.
here 01 is domain and 04 is station.

Answer / praven kumar m

In Yokogawa System if the no. of station is 56 or less than
56 the domain no, will be domain#1. If it exceeds more than
56 stations then we have to consider 2 domains (i.e.,
domain#1 and domain#2)

For eg. if there are 2 units, and the first unit consists
of 65 stations. in this case the first 56 stations will be
considered as domain#1 and station nos. from 57 to 65 will
be considered as domain#2. The 2nd unit will be considered
as domain#3.

Answer / prabhakaran

Domain means combination of both FCS and HIS system.
Station means Field control station (FCS).

Is Hart communicator calibration device or communicating device for transmitter?

4 Answers   Yokogawa,

---

Generally in which location ( JB or IO card or DCS) the thermocouple compensation is done.Also where they measure the atmosphere temp ( for compensation) in JB OR DCS panel? How they compensating that atmosphere temp? is any circuit for that ( like in rtd wheatstone bridge)?

3 Answers  

---

plz send me general of ongc

0 Answers   ONGC,

---

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers  

---

What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?

0 Answers   Process Control Technologies,

---

---

HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with

0 Answers   GSM, IOCL,

---

How to calculate the flow rate in Vortex flow meter?What is K factor?Can you give me an example calculation to understand the same as better?

1 Answers   npcc, Zadco,

---

What are the characteristics of Control Valve

2 Answers   Ispat,

---

What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.

3 Answers   ADMA OPCO,

---

WHAT IS THE DIFFERENCE B/W PLC and DCS

10 Answers   Bhel,

---

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

What are different types of orifice plates?

0 Answers  

---