what is the Difference Between Domain and Station?
- 3 Answers
- 9738 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / praven kumar m
In Yokogawa System if the no. of station is 56 or less than
56 the domain no, will be domain#1. If it exceeds more than
56 stations then we have to consider 2 domains (i.e.,
domain#1 and domain#2)
For eg. if there are 2 units, and the first unit consists
of 65 stations. in this case the first 56 stations will be
considered as domain#1 and station nos. from 57 to 65 will
be considered as domain#2. The 2nd unit will be considered
as domain#3.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
How u measure the massflow in orifice flow measurement techniques
how is work pressure switch& level switch?what is the principle of this?
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is sensitivity in vibration probes..?
Explain the difference between mmwc and mmwg?
How to work togather like sov,limit switch,proxy switch and booster in xv
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What is the use of temperature compensation?
what is the reason while warning lamp is on while the engine is cranking?
can we copy the software from a transmitter using hht(hart 275) ?
Explain how thw analog to digital converter works with the circuit diagram
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
