Answer / a.p.nanjappa

we use :33kv power supply-1.2x33/1,732kv voltage rating,for
current -5ka or 10kA , the nearest value as per selection
guide bymanufacturer

What is the difference in Line PT & Bus PT.

3 Answers   Bhel,

---

What must be the minimum distance maintained between 2 Generators as per International standards?

0 Answers  

---

A shopkeeper allows 10% discount on the price of an article and sells it for Rs 7,600. What is the marked price of the article?

1 Answers  

---

when elecromagnatic waves are propogated in a wave guide?

0 Answers  

---

what is power factor

7 Answers   Eskom,

---

If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)

0 Answers  

---

What are the probable causes for failure of heating elements

4 Answers   BARC,

---

when the supply of MSEB is cut off & all the load of the industry is driven on generator at that time the capacitor which is connected in industry for power factor control is switched off why?

1 Answers  

---

Why we use a shunt capacitor or synchronizing Motor To Improve a Power factor pls reply me in this mail dinesh_elect_eng@yahoo.com

4 Answers  

---

For DG set,if the loading is increased,does flue gas temperature increases or not?

2 Answers   NTPC,

---

if we connect a ohmmeter across shorted capacitor .what will be the reading..will it be zero or infinity

2 Answers  

---

what is the difference between the 94 lockout relay and 86 lock out relay. I have noticed that the 94 lockout relay is activated when the distance realy is activated and 86 is activated when the 87T differential is activated. but why can't the same lockouts be used for both the protection schemes

10 Answers   ABB,

---