if its possible for step up or step down DC volage directly ? possible means

Categories >> Engineering >> Electrical Engineering
Suggest New Category

if its possible for step up or step down DC volage
directly ? possible means how we can do it ?

Question Posted / kumar

5 Answers
10016 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if its possible for step up or step down DC volage directly ? possible means how we can do it ?..

Answer / ankit

as far as i know indirectly we can use choppers to step up &
step down.

Is This Answer Correct ?

13 Yes

0 No

if its possible for step up or step down DC volage directly ? possible means how we can do it ?..

Answer / raghavendran

We can use BUCK BOOST Converters for stepping up or stepping
down the DC Voltages.

Is This Answer Correct ?

2 Yes

1 No

if its possible for step up or step down DC volage directly ? possible means how we can do it ?..

Answer / syed shoeb ullah hussaini

yes, it is possible to step up or
step down the DC voltage with
the help of BUCK AND BOOST
CONVERTERS
buck converter is used to step
down the dc voltage and
boost converter is used to
step up the dc voltage ....

Is This Answer Correct ?

1 Yes

0 No

if its possible for step up or step down DC volage directly ? possible means how we can do it ?..

Answer / ramarpandi

rheostat

Is This Answer Correct ?

2 Yes

3 No

if its possible for step up or step down DC volage directly ? possible means how we can do it ?..

Answer / azarudeen

by using we can amplify(step up/step down) the magnitude of
DC voltage.

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

why is the size of earth conductor is half of phase conductor.

1 Answers Century Pulp and Paper, L&T,

what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?

0 Answers

i need to give section engineer (electrical engineer) for RRB. Please suggest some book

0 Answers

how to revers the direction of single phase motor

0 Answers

What is current chopping in CB?

1 Answers

what is parellel power factor correction?

2 Answers HCL,

why are we adopting 132kv,220kv for transmission rather than using 440kv at all transmission lines as it gives lower losses?

2 Answers APGenco,

For an 100kw generator, only 50kw of load is connected. Will the generator generate only 50kw or 100kw. If it generate 100kw what happens to rest of the 50kw. What happens if we connect more than 100kw of load?

2 Answers L&T,

In India,we use 230V,50HZ,where as many other countries use 110V,60HZ what r d advantages and disadvantages of each of them?

8 Answers GVK,

how to calculate micom relay earth falt time and current sertting

0 Answers

how am i achived model paper to prepratio for bhel exam

2 Answers Bhel,

As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.

0 Answers

For more Electrical Engineering Interview Questions Click Here