Answer / a.p.nanjappa

THIS IS ONE OF THE MANUFACTURER TEST OF VECTOR GROUP.
IN THIS TEST , THE HV RPh or Uph is connected to low voltage
rPh. /uPh. then 400v 3ph is applied. various voltage are
measured. (RS,ST,TR, R-N,S-N.T-N, r-s,s-t,t-r, r-N,s-n,t-n.

then, draw the graph,
refer to electrical hand book-transformer, any text book
also,manufacturer test report

What do you mean by phasors?

0 Answers  

---

how to calculate power factor of capacitor? what is transformer rating?

2 Answers  

---

any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?

0 Answers  

---

block diagram of 2 ups system connected in parallel mode?

0 Answers  

---

which is dangerous AC or DC? If so why?

4 Answers  

---

Whether capacitor loads can be connected for testing a diesel engine at its full load capacity? Is there any limitation of capacotir load? Which is the best load for testing DG sets?

2 Answers  

---

what will happen if OLR CT in all phases are short circuted

0 Answers   Indfrag Limited,

---

How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.

0 Answers   Taj Group, Tata Steel Limited,

---

How we calucate of DC moter I/AMP?

3 Answers  

---

what is the highest voltage for transmitting electrical power in india

5 Answers  

---

what is tan delta measurement?..... why that terminal is earthed.....?

4 Answers   Power Grid,

---

In neutral the current will flow or not?

17 Answers  

---