I have seen the Temperature element (T/C & RTD) installed in process line on 45 degree position, Why? What it mean? How many types of tapping position for temperature elements?

4 Answers  

---

how to work MIL contol valve posistioner ?

0 Answers   ABB,

---

what is solenoid valve?

6 Answers   Hindustan Zinc,

---

Are Coils of Electromagnetic flowmeter in direct contact with fluid material

4 Answers   TATA,

---

We have yokogawa cs3000 one fcs and 4 his. After download to his, showing successfully at es, but not transferred to his.

1 Answers   Shyam Steel,

---

how to test rotor &stator earth fault in turbine

1 Answers   Bhel,

---

How will you calibrate an interface level trol/normal level trol in line and in w/s?

1 Answers   CCIE,

---

why the derivative in PID is always set to zero?

3 Answers  

---

the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove

0 Answers  

---

What is the deffernce bet. Instrumentation and Electrical Enginerring?

1 Answers  

---

What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?

2 Answers  

---

what is modbus?and why use it?what benifit

2 Answers  

---