in ceiling fan and table fan what is the rotating part and
what is the stationary part?
Answers were Sorted based on User's Feedback
Answer / nish
in a table fan rotor is just like a general purpose rotor and its rotating where as in celing fan coil wonded part is rotating n rotor is stationary......
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / k.prakashchandra
In both, the squirrel cage armature is the rotor.In table
fan the rotor is inside the field and in case of the ceiling
,the rotor is outside the field.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / s.v.khandekar
in a table fan rotar(non winded part) is a rotating part
like general purpose motor ,wherw as in ceiling fan rotor
(non winded part in a centre has stationary and outer part
having winding is a rotary part hence the the rotation of
the blade also having anti clock wise ,just reverse of the
table fan.
Is This Answer Correct ? | 1 Yes | 3 No |
Answer / liactro7
In sealing fan coil have a rotatory part, but in-case of
table fan coil should stationary and shaft connected with
fan leaf is rotor part.
Is This Answer Correct ? | 1 Yes | 4 No |
Dear all i want to know FEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me shibin_75@yahoo.com
what will happen if capacitor bank is used in generation side?
Why we use circular(Stepped) cross section in transformer core?
How to calculate the NGR value for a 2.7MVA Transfomer, 11KV system where the fault current has to be limited to 50A?
how long will take to burst/damage for a CT when secondary in open condition? Experienced: During switchgear testing(Primary current injection test) some of the CT are in open condition, but nothing happen's why?
how to select the rating of neutral ct with reference to transformer secondary current(in power transformer,stepdown tansformer,for example2000kva,11kv/415volt
WHAT IS SYNCHRONISING?
WHAT IS THE DIFFERENT BETWEEN MCB & MPCB? & HOW IS USE?
In winding design, the angle of chording (β) is nearly equal to A 45 degree B 60 degree C 30 degree D 90 degree
why scott connection is done why not two phases are directly picked at the output of 3 phase transformer??
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.