in ceiling fan and table fan what is the rotating part and
what is the stationary part?
- 5 Answers
- 9094 Views
- I also Faced
- E-Mail Answers
Answer Posted / nish
in a table fan rotor is just like a general purpose rotor and its rotating where as in celing fan coil wonded part is rotating n rotor is stationary......
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
describe the Operation of induction generators from bus bars
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
state the working principle of incondenscent tube?
What is dc current source? Differentiate between ideal and non ideal current sources?
Why do we use center tap transformer that used with portable tools
how to calculate power consumption in slip ring motor at different step
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
how to find the multiplication factor for digital energy meter and analog energy meter
What is Instantaneous Earth fault relay,how will work
why the neutral point in connnection oscillates?
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
What is the control action?
how to decide no of electrodes for 1600A LT Main incomer panel
