What is the use of centrifugal switch in 1phase induction
motor? Why is it so called?

Answers were Sorted based on User's Feedback



What is the use of centrifugal switch in 1phase induction motor? Why is it so called?..

Answer / suresh l

it is used to disconnect the auxilary winding while the
motor in running position.It is so called because it works
on centrifugal forces

Is This Answer Correct ?    32 Yes 1 No

What is the use of centrifugal switch in 1phase induction motor? Why is it so called?..

Answer / veeresh kumar.m.

it is used for disconnecting the auxilary(starting)winding
of motor when its speed is reach 75%,that means the
auxilary winding is open in circuit when motor is in
running condition.
it is working on centrifugal force system.

Is This Answer Correct ?    24 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

i am using auto transformer for starting of induction motor to provide reduse voltages...but the principle of a tansformer according to definition"which transform energy to on circuit to another circuit with constant power and constant frequency". so if i am using reduse voltage then current obsely hige because power is same.but we use auto transfarmer for starting of induction motor to give low current.but here according to definition we are giving hige current.

0 Answers  


What is the unit of magnetic flux density?

0 Answers  


why battery is connected in parallel ?

7 Answers  


What is water cooled chiller plant?

1 Answers   Gulf, IOCL,


How to reduce power factor correction capacitors failure in an industrial environment with vsd and computers usage in the system

2 Answers   ABB,






how we do Vector group ,magnetic balance and tap changer test in Transformer?

0 Answers   Afcons, BSL, HPL,


will 1050kva DG set withstand for back charge of 16MVA transformer

0 Answers  


In Energy meter How many rotation Equal to one unit.

3 Answers  


what is the cause of voltage dipp or swell in the transmission lines?

0 Answers  


i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.

0 Answers   Bay Fishing Corporation,


how to calculate the mf of kwh meter,if ct the ratio on meter is 100/5A

2 Answers  


Difference between on line capacitor and Station type capacitor

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)