Answer / k.prakashchandra

Input to single phase motor is 1150 VA, whereas to 3 phase
is about 1000 VA (line voltage=230 V)per HP. The efficiency
of single phase motor is less than that of 3 phase.

We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.

0 Answers  

---

What is hysteresis losses?

2 Answers   GMR,

---

FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?

0 Answers  

---

when we start the tube light, then it takes initially 1100 volt, after glow it takes 120 volt?(when we give 220 volt a.c.)

3 Answers  

---

why d.c produces corrosion

0 Answers  

---

wat s reactive power.... how could it be compensated.....

4 Answers   TCS,

---

Hp to Kw and Kw to I(amps) conversion......

3 Answers  

---

Which starter can be used for 3 phase verriable speed (2 stator wdg) induction motor ?

2 Answers  

---

What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer

0 Answers   Equate,

---

WHY DG are rated in KVA or MVA ???., but ALL power plants are rated in KW or MW.,,?

3 Answers   Coastal Energen,

---

What is the two pole structure?

0 Answers   Foxconn,

---

why we use 11 kv 22 kv and so on ?

1 Answers   Air Force,

---