Answer / k.prakashchandra

It is not easy to calculate with variable load.Fix energy meters

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers   Air Force,

---

how many joint can done in HT line and what is life of the joint

0 Answers   Micro Labs, Reliance,

---

I have 150/1A Rating CT Suppose if i inject 15A in CT " Secondary" means what will happen ??????

1 Answers  

---

What is C-factor?why it is required to consider in fault short circuit calculations?

2 Answers  

---

what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker

1 Answers   Siemens,

---

HOW TO CALCULATE EHV CABLE SIZING?

2 Answers   L&T,

---

I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???

0 Answers  

---

sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.

0 Answers  

---

what is the voltage between earth & neutral in 3 phase electrical connection.

0 Answers   Megatron Solutions, SIPL,

---

How does a star connection and delta connection work? How does the star connection save starting current and how does it change to delta?

3 Answers  

---

10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)

0 Answers   CTS, Jindal,

---

i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400

0 Answers  

---