Answer / aftab ahmed mazari

Cages are used in control valves for following purposes:
1. To determine chracteristics of flow.(Equal percentage,
Linear, Quick opening)
2. To avoid flashing and cavitation in control valve.
aftabmazari@yahoo.com

What is the use instrument barriers? Can you give me review materials about this?

1 Answers  

---

What is a PID controller and how can it to applied to our everyday life?

4 Answers  

---

in instrumentation why we are using 4-20mA , why not voltage ? if somebody design a instrument which works on voltage then can we use that instrument?

6 Answers  

---

hye SAM acn u send your e mail id, so that i can solve my query through e mail?

0 Answers  

---

How to check the SCAN time of DCS ,n dont give therotical answers .How to check the SCAN time of DCS during FAT?

2 Answers  

---

why generation of syncronized generator increases when frequency of grid is less then 50Hz & generation decreases when grid frequency goes up from 50 Hz, as comparision with set value entered in govering panel?

1 Answers  

---

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers  

---

Why 4mA-20mA current loop selected as standard ???

1 Answers   IMCO, Reliance,

---

What is linearity of RTD over 0 to 200 degC?

1 Answers   Honeywell,

---

pls give me presant awerness quistion and answer in my emailid.

0 Answers  

---

If Solenoidal valve works in manual mode but not in Auto mode. What should be the problem?

8 Answers   Bharathi Cement, Titanium,

---

what are the levels of automation?

1 Answers  

---