Answer / hamid

on the vibration probe we start by cheking the resistance of the probe
than we check the linearity using the tk-3

how to define the P,I,D value in tuning pid loops in online.

1 Answers   Thermax,

---

why we are using magnet for calibration of gas detector?

0 Answers   NSH,

---

what is sliding spool valves?

0 Answers  

---

what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?

0 Answers   Essar,

---

how to commission furnace ( water heater)

0 Answers   Petrofac,

---

What is the difference between pt100, pt500 and pt1000 RTDs?

3 Answers   ICI Pakistan,

---

Can anyone say that formula of Converting the Diff. Pressure into Flow in Kg/Cm2 or any explaniation of Orifice Plate, Beta Ratio , How to calculate

1 Answers  

---

i am confusing about differential pressure transmitter as i seen so many DPTs in different ranges how can we calculate level and flow with mmh20 plz tel me

1 Answers  

---

I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .

0 Answers  

---

While giving Power Supply of 24 VDC to a Transmitter,why Shield Terminal is connected either at Transmitter or at ISB.Why not Shield Terminal connected at both ends.If the Reason is to avoid Noise interference,which type of noice that is interfering.Is the Noice from the 24 VDC supply terminals or from any external source.

1 Answers  

---

what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??

0 Answers  

---

how to calibrate the interface leveltrol

1 Answers   Lanco,

---