GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.

7 Answers   DVC,

---

what are the basic instructions used in simatic s7-300 plc?

5 Answers   Dr Reddys, HZL, Siemens,

---

what is puling in n pulling out in flame scanner system?

1 Answers  

---

Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?

0 Answers  

---

A pressure Tx accuracy is 0.2%. Signal o/p is 4-20ma.span is 16 Ma.how many deviate the o/p then calibration needed

1 Answers  

---

what is meant by nuclear power plant?

1 Answers  

---

Can anyone send most commonly asked interview question in Oil & Gas industry

0 Answers  

---

how magentic flow tx. vortex flow tx & ultrasonic flow tx works and its prinicle?its callibtration prosedure?

1 Answers  

---

If we increase PI controller what will be action.

1 Answers   IMECO,

---

Wht should be the ratio of natural frequency (Fn) to wake frequency (Fw) and wht if goes above the rato limit?

2 Answers  

---

How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?

0 Answers   Tecnimont,

---

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

0 Answers  

---