Answer / venkatesh kulkarni

No in star delta shhematic first Main contactor & star
contactor will operate & after few seconds main & delta
contactors will operate, star contactor will switch off. if
we connect OLr in Delta circuit in star operation
protection will be not be there so it is not recomonded to
connect OLR in Delta circuit.

Answer / harish .v n

in star I(l)=I(ph),where as in delta Il not equal to Iph ,,, so connecting OLR is not recommended in delta circuit.

i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?

0 Answers  

---

What are applications of Shunt release?

2 Answers   Techno Electric and Engineering,

---

What is clock position of Transformer?what are the clock positions are there?and what is different of them?

0 Answers   Synergy,

---

In a synchronous motor armature current flows due to revolving flux which in turn rotates the load,but in no load condition armature current is zero hence thr is no revolving flux then how motor rotates?

9 Answers  

---

In underground cables,we have a grading method called 'capacitance grading'.Why is it called 'capacitance grading' although we do not use any capacitor in it?

1 Answers  

---

what is the different between bus section and bus coupler

1 Answers  

---

In my project i am layout cables under the Maintainance bay /Maintainance yard in the TG Building. Whether in this route i can lay the H.T.Cables??? i am taking all H.T cables from the H.T Transformer to the TG Building..

1 Answers  

---

why do mostly prefer to generate and distribute electricity in 3 phase..not in 4 phase or 5 phase.??

5 Answers   BSBK, IOCL, NTPC,

---

Which type of losses in transmission Line

2 Answers  

---

300m long and 30kw inductive loade 3phase supply how many size cable required

0 Answers  

---

flurescent bulb rating is to 230v,50HZ.now flurescent connected 230v,25HZ.whether nreduced frequency will affect the glowing properties of flurescent.

6 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---