Answer / shaikh moyunuddin

for rcc minimum M20 grade is used
it's depend how's the building is design
& m20 propotion is 1:1.5:3(cement:sand:aggregate)
& for water 40 to 55%
total area of rcc

Answer / sandip

the water cement ratio of m-20( 1 : 1 1/2 : 3 ) is taken normally 0.45 . Example for 1 cmt m-20 grade of concrete cement consumption is around 350 kg, thus the water consumption will be as below

consumption of water = cement x 0.45

= 380 x 0.45

= 171.00 kg ( =188 lit )

Answer / csr

It depends on which grade we are using and it depends on
the required strength.
minimum we start from M15 1:2:4,
M20 1:1.5:3,
M25 1:1:2

Answer / aabid

.40% water cement ratio

Answer / shri

m20 1:1.5:3 Cement:Fine aggregate:coarse aggregate water in ratio 0.5

Answer / hiren

in rcc generally M-20 is used hence for M-20 proportion are
1:1.5:3.... c:ca:water

Answer / fathi abu sabha

for m20 1:3:6 , cement ,sand , aggregate
for m30 1:2:4 , cement ,sand , aggregate

What is difference between limit state and working stress method? How it is applies in building structure.

2 Answers   L&T,

which software is better for design and analysis of buildings (stadd pro ) or (Etabs)

0 Answers   CCCL,

how many shuttering material required for 1000 sq.m built up area.

0 Answers   ABC, CGHB,

I heard Thump rule about beam depth is 1" per 1' length. Is this correct? If not please tell me the thump rule.Thanks.

2 Answers  

If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available in the construction site but the beam has to cast in an emergency. Which dia of bar is to be used for for that situation? (If greater than 16 dia bar is not available at site)

2 Answers   Shreeji Associates,

How to compute minimum number of columns required for a site from area of site?

0 Answers  

In which direction is bottom bar of rectangular footing is placed in short or long.

1 Answers   AKC,

What is alternate bid?

0 Answers  

where cross hairs in surveying telescope are fitted

2 Answers  

what is mix design

23 Answers   Power Grid,

What is the significance of cost estimate knowledge for an architect?

0 Answers  

what is the tensile strength of 10swg and 8swg gabion wire?

0 Answers