in an ac series circuit there are 30 bulbs are connected in a serial set.what w

in an ac series circuit there are 30 bulbs are connected in
a serial set.what will happen if one bulb is fused and we
removed the bulb and reconnect with the remaining bulbs? (29
bulbs). will the brightness of other bulbs increase or not?

Question Posted / rajkumar85

3 Answers
8139 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bu..

Answer / satheesh

The applied voltage divided by the total series resistance is the current passing through the bulbs since it is in series.When one bulb is fused there is a reduction in resistance and prorate increase in current.so corresponding increase in brightness definitely be there.

Is This Answer Correct ?

16 Yes

5 No

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bu..

Answer / pillay

when they are connected in series and one of them is removed
then the Resistance reduces and would result in more current
flow. This would result with a brighter light.

Is This Answer Correct ?

7 Yes

2 No

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bu..

Answer / gaurav kaushal

Yes, It will increase definately.,

Is This Answer Correct ?

11 Yes

7 No

Post New Answer

More Electrical Engineering Interview Questions

Why the steam turbines are run at high speed where as the hydro turbines are run at low speed?

1 Answers

i am working in automation feild my question is that how to find the KVA of transformer.

3 Answers

What are various impedence in any machine

2 Answers Engineers India Limited, NTPC,

i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected

0 Answers TNEB Tamil Nadu Electricity Board,

How to calculate voltage drop loss in HT 11000 Volts XLPE Aluminium conductor cable. Any specific formula or Thumb rule

2 Answers

it says in neutral wire current flows under normal condition, but when we put tester it wont glow, why?

7 Answers HCL,

why breaker closing coil gets burnt if supply is continously provided to it.

1 Answers TATA,

How can remove the jerks on genretor due to remov or connecting the load ?

3 Answers

What is VCC?

1 Answers

7. A resistance of 30 ohm is connected across 240v supply. If a resistance R ohm is connected in parallel with 30ohm resistor across the same supply, the current drawn becomes triple of original one The unknown resistor R is

2 Answers

why microprocessors are named as 8085 ,8086 etc? what's the reason for this???

15 Answers Bhel, HCL,

why cannot we use a freuency more than 400hz is used in aircrafts?

1 Answers

For more Electrical Engineering Interview Questions Click Here