Answer / jay

RISE TIME
Rise time is the difference between the time when the signal
crosses a low threshold to the time when the signal crosses
the high threshold. It can be absolute or percent
HALF TIME
The time between the virtual zero time and the time to reach
half of the peak during the decay (not sure about half time)

why ht alternators gland plats using brass?

1 Answers   ONGC,

---

Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.

0 Answers  

---

explain working of differential protection for a transformer?

1 Answers   BARC,

---

what role neutral plays in electrical circuit? If neutral is not there what will be the effect

1 Answers  

---

how electronic energy meter works?

12 Answers  

---

Best way to measure the Soil resistance of rocky soil, three probe method and four probe method

0 Answers  

---

why in three phase 440 circuit in all phase current is almost equal L1-35 A,L2-34 A ,L3-31 A but in nutral when i check with clamp meter it shows 25 A?

4 Answers   OPS,

---

how to calculate EXCITATION VOLTAGE & CURRENT in ALTERNATOR

0 Answers  

---

Whats the frequency used in Rodents Repllant System????? What is the Diff btw Infrasonic & Ultrasonic Frquencies???

1 Answers   Emerson,

---

What is the automatic voltage regulator with servomotor?

0 Answers   Simbhaoli Sugars,

---

WHAT HAPPEN WHEN A DROP OF WATER MIXED UP WITH TRANSFORMER OIL ?

4 Answers  

---

how to calulate multiplying factor if meter ratio is /5 ampere and ct ratio is 100/5 ampere.(our supply is 3 phase 415 volts)what is multiply factor?

3 Answers   Vivek Engineers,

---