When we use a multimeter, while checking continuity of a closed circuit , wha

When we use a multimeter, while checking continuity of a
closed circuit , what is happening inside multimeter, how
it is working to produce a beep wheather it is closed or
open.. is there any internaly voltage/current source
inside multimeter?

Question Posted / chandrasekarapandian

3 Answers
8500 Views
TNEB Tamil Nadu Electricity Board, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

When we use a multimeter, while checking continuity of a closed circuit , what is happening insid..

Answer / ankush

Yes there is a battery inside the multimeter 12v
n the ckt of the multimeter completes when two of its pins
touches.
similarly when there is closed ckt the continuity beaps n
in open ckt no beap is there.

Is This Answer Correct ?

8 Yes

2 No

When we use a multimeter, while checking continuity of a closed circuit , what is happening insid..

Answer / vicky

Its simple.. every multimeter operates under a battery
source.. it vil just send the current in micro or milli amps
to check the continuity...

Is This Answer Correct ?

2 Yes

0 No

When we use a multimeter, while checking continuity of a closed circuit , what is happening insid..

Answer / hkrish.eee

scr used

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

TELL ME WHAT IS INDUCTOR AND CAPACITOR WHAT IS IT BASIC OPERATION ANDFUNCTION?

0 Answers ABC,

how many earthing required for ups, what should be the earth voltages

9 Answers Juniper Networks,

What are the functions of different probes used in cro?

0 Answers

How to create a SCADA diagram on PC? I run the DG everyday but i dont know how that animated single line diagram is created.Please answer.

1 Answers

15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help

0 Answers

Can i get some examples of mechanical devices?

1 Answers

how we can calculate which capacity capacitor bank we have to add for improve pf?

3 Answers Consultancy, JM Huber, Torrent Power,

while calculating the power absorbed by a resistor connected to the output of a half wave rectifier circuit should we use rms or average current? explain with reason.

1 Answers Vedanta,

when we r using single phase load and we have power cable of 3.5core with .5 of neutral and neutral is suppose to the returen path of the phase how much current will flow in the neutral.reply.

2 Answers

a solar energy installation utilizes a three phase bridge converter to feed energy into power system through a transformer of 400v/400v.the energy is collected in a bank of 400v battery and is connected to converter through a large filter choke of resistance 10ohms.1.the maximum current through the battrey will be.2.the kva rating of the input transformer is.

1 Answers GATE,

What accessories required to give the motor with given circuits and do you know the ratings of those accessories?

4 Answers Hyundai, TCS,

At which time Synchronous generator act as a Synchronous Condenser?

4 Answers

For more Electrical Engineering Interview Questions Click Here