can anyone plz tell me
in 3 phase induction motor, whare we use STAR CONNECTED MOTOR
and whare we use DELTA CONNECTED MOTOR
Answers were Sorted based on User's Feedback
Answer / balu
In star connected motor is used for low torque purpose.
And delta connected motor is used for high torque purpose.
Is This Answer Correct ? | 10 Yes | 3 No |
Answer / geetartha
star connection is used for ht motors and delta connection
fot lt motors
Is This Answer Correct ? | 5 Yes | 0 No |
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
why the Parameters : Base Voltage & Maximum Voltage can't be equal in value in a VFD (Variable Frequency Drive) ? How much the base voltage would be lower than the maximum voltage ? If 400 V is the 3 phase output of a VFD ... then what should be the base voltage ? thanks a lot
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
any body know about lighting arrestor. how to determine the height of lighting rod from top of bulding and how many area it cover.
advantage,disadvantage,aplication of sensorless direct torque control of induction motor
How can w select the cable size for different rating load & also waht r factors affecting the during selection of cable?
11 Answers AB Inc, Bosch, BRB Cable, Lucas TVS, Trisome Technical Services,
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
HOW TO CONNECT THREE PHASE OVER LOAD RELAY FOR SINGLE PHASE
At what factor resistance r of a conductor depends?
We have ONLINE UPS 15KvA (3PHASE 440V I/P,3PHASE O/P,440V) I want to step down from 440 to 220 V What to do. Pl. suggest with specification.
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
why there is a temperature rise at different metal to metal contact at cable lug??suppose cable is aluminium and the lug is copper,than why the temperature rise takes place??