Answer / anand yadav

In most cases, on load tap changer is provided at higher
voltage & lower current side.It is economical.

Answer / a.muthukumar

Always ON LOAD TAP changer is provied in HV side only.
Because HV side current is low and LV side current is high.
So, during on load tap changing losses will be reduced when
on load tap changer is in HV side.

insulators advantage in transformer yard?

1 Answers  

---

what will happen if OLR CT in all phases are short circuted

0 Answers   Indfrag Limited,

---

Can clean earth cable be considered as low current cable

0 Answers  

---

How check proper electrical earthing of machine.

5 Answers   DRJ ARDE,

---

Why power factor should not be in leading (capacitive) mode of any load.

3 Answers   GE,

---

1.difference between sts & ats? 2.what is fm200 system brefly explain?

1 Answers   Ericsson,

---

Why transformer ratings in KVA not in KW?

6 Answers   ABB,

---

what is servo motor & how does it work.

0 Answers  

---

Which do you think is the most significant cause of energy loss in a factory?

0 Answers  

---

What is maximum demand and contract demand?

5 Answers  

---

what is Over current, earth fault (O/C+E/F) ?

2 Answers  

---

I have 380.KVA DG set how to Calculate the units from DG.

2 Answers   Ozone Pharma, Sperry Plast Limited, Sterling,

---