what will hapen if we give ac supply to dc motor?
Answers were Sorted based on User's Feedback
Answer / apoorv
It depends on whether the field winding of the dc motor is connected in series or in shunt with the armature winding.If it is connected in series,the motor will rotate since the torque,which varies as the product of the armature and field current is always positive.Thus,a positive average torque causes the motor to rotate,however the pulsating nature may cause the commutator segments and brushes to wear out.
Thus only small sized dc motors may be used with ac supply.
Read more: http://wiki.answers.com/Q/What_will_happen_if_you_give_AC_supply_to_a_DC_motor#ixzz1PFQibbRO
| Is This Answer Correct ? | 8 Yes | 0 No |
Answer / akki
Simple as always the dc motor in most cases would not even
start but if it does the load capacity would be like
pathetic
| Is This Answer Correct ? | 3 Yes | 6 No |
In a Synchronous generator, Can AC voltage be used instead of DC voltage in field winding of rotor to produce AC power?
what is the difference withbeen lighting capacitor and motor capacitor?
If single phase voltage level is 230V than why three phase voltage level is not 660V ?, but it is only 440V.
16 Answers BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp,
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
0 Answers Eprosys Engineering Consultants,
What will happen if we give AC supply to DC motor?
whether the battery is voltage source or current source?
What is the different between buchholz relay and pressure relief device?
is the surge effect the solar panel, if yes so tell me how can surge effect the panel? explain brifly
why in india the voltage generate multiply by 11,,,like 220v,440v,11kv,33kv,66kv,220kv,
3 Answers NTPC, Servotech, Tata Power,
The armature of shunt dc motor has 0.8ohm resistance and motor is to run on 120V circuit.If motor is suddenly thrown on circuit while armature at standstill then current drawn by motor will be??Also back emf in normal running is 110V
Power systems
waht is the working principle of saft starter & what is the difference in vfd & saft starter
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)