What are the disadvantges of leading power factor
Answers were Sorted based on User's Feedback
Answer / waqasahmad
Dear ZAFAR when we talk about generator , due to leading power factor the end structure of generator will over heated and this over heating occur due to the leakage flux in core and set up eddy current.
in leading power factor operation the generator will be less stable because we are importing reactive power from the system
that's why we reliay on system, if there is a disturbance in the system our unit will also effected.so in this condition our reliability will be poor.
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / shahriar
dear waqasahmad,would u plz tell
me what pf is maintaind at the
generation side?leading or
lagging?
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / d k j
in leading power factor, every electrical equpment not
given 100 % efficienvy and its defect at log time in
equpment. and losses of voltag at consumer and ganretion
side also.
| Is This Answer Correct ? | 0 Yes | 3 No |
the leading power factor is one type of westage of
electrical energy its means ane type of losses in our
electrical equipment. loss energy can't use any one so its a
one type of westage of money.
| Is This Answer Correct ? | 0 Yes | 7 No |
Answer / syed ali raza naqvi
the disadvantages of a leading power factor that the to
much current passes and meter running fast n bill is
increase.
| Is This Answer Correct ? | 1 Yes | 10 No |
What is an infinite bus bar?
i have 3, 75hp motors and 10, 15 hp motors....and to run this motors continously with a generator how much rating(kva) of generator will suiteble....?
HT/LT TRANSFORMER TEST?
what is the criteria for selection of conductor used for ehv ac electrical dischrge
0 Answers National Productivity Council,
Can u tell me design of switch yard
What is the function of Buchholz relay in transformer ?
whatis knee point ?
what the function breaker failure scheme, how is it operated
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
why the voltage and current in a long transmission line are called travelling wave?
Why the steam turbines are run at high speed where as the hydro turbines are run at low speed?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)