Answer / abid hussain

Because in AC Motor the motor winding is according to ac
supply and its impedence is too high due to frequency but
when we will DC Power source to same type motor the
impedence of motor will go down due to no frequency this
cause high current flow through the motor winding and it
will be burn or damage.

Answer / sundarrajan

motor doesn't run.
if the motore runs power loss is higher,efficiency of motor
is reduced.

Answer / ram

the winding insulation get damage due to the mmf. the
insulation of the winding depends upon the volatge only not
on flux.

why we have to do tan delta test of the transformer oil???

5 Answers  

---

magnetizer priciple

0 Answers  

---

How to calculate wire length,size & current? ( related to control panel)

0 Answers   FSS, GK Controls, Panel Tech,

---

stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate

0 Answers  

---

In power transformer tappings are provided on A high voltage side B low voltage side C In middle of both the windings D both high and low voltage side

2 Answers   NNN,

---

what is meant by insulation voltage in cables? explain it?

4 Answers   ABB,

---

what do you mean by class PS CT and what are technical details needed for calculating it?

0 Answers  

---

What is DG B-check and C-Check

1 Answers  

---

Why auxiliary transformers are not connected in parallel in primary stations?

0 Answers   Adweb,

---

why the AC or DC motor takes high starting current?

2 Answers  

---

which strater used genearalyy???and why???

1 Answers  

---

which one cable has a more resistance.A big or small

2 Answers  

---