Dir sir we have 750 kva Caterpillar dg set we are fas on
different problem we start dg set ofter 1 mint apply load
around 500a dg was run one or 3 mint after 3 mints dg was
shutdown automatic how to face tis problem
Answers were Sorted based on User's Feedback
Answer / afzaal
it seems no issue with prime mover as it starts smoth but some protection make it trip..do check that...weather overcurrent(overload)...u have not mentioned voltage? do mentioned that
| Is This Answer Correct ? | 0 Yes | 0 No |
Difference between mcband isolator
define reluctance motor & its operation ?whether its operating single phase or three phase ?
WHAT WILL HAPPEN WHEN THE MOTOR FREQUENCY INCREASED OVER THE RATED MOTOR RPM THROUGH DRIVE?
what is the relation between KVAR,KVA,KW?why we are mentioning capcitor rating in kvar?what is meant by arcing horn and horn gap in transformer?what is equipotential wire?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
IN CABLE TRENCH WHY FILL UP THE SAND. AND WHAT IS THE DIFFERENCE BETWEEN OVER HEAD AND UNDER GROUND LAYING THE CABLES
why master trip(86) used in eletromagnet?
What is mechanical interlock?Explain the uses?
What are books to be referred for KPTCL exam?
in dc shunt motor if field winding is shorted then
what is corona effect?
39 Answers ABB, Genco, Wipro,
what is surge suppressor?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)