Answer / mrmk

The correct term is K Factor.Normally this value can be
calculated in factory calibration and at field using meter
proving skids.

If the on Of the DO module is off in the System cabinet, then what is the Procedure to check weather the Module is working or not.

2 Answers   Honeywell,

---

what is performance test.need defination

0 Answers   Takreer,

---

Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers  

---

why does a transmitter o/o signal starts from 3-15psi or 4- 20mA?

11 Answers  

---

can any one give me the cost price of yokogawa & rosemount transmitters

4 Answers  

---

What is the difference between PLC and DDC?

0 Answers   Emami,

---

I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.

0 Answers  

---

Why we use 250 ohm resister in series hart communicator?

3 Answers   Thermax,

---

What is the working principle of oxygen analyzers(zirconium oxide type) used in CFBC boilers?

3 Answers   Bajaj, Kohinoor, Wartsila,

---

WHERE I CAN GET THE TRAINING SMARTPLANT INTOOLS V7 IN INDIA

0 Answers  

---

why is honed type flow orifice plate? what purpose it used? how to select this?

4 Answers  

---

What are the error values can accepted in flow transmitter calibration?could u give any formula for this?

0 Answers   Hamsco,

---