Answer / p. sudhagar

Megger is used to checking in insulation value,Its used to
high voltage injunction purpose and checking the polarity.
Contact resistance meter used to checked the contact
resistance value, Its injected the 100A only So its
resistance value low.

Answer / sanjeev

megger is a insulation Resistance checking with applied voltage for checking purpose but contact resistance meter only measuring in oms

Is a DC Transformer Possible? if Yes, Then Why, if not Then Why?

9 Answers  

---

How to measure the earth resistance value in a concrete pavement(flood light area)?

0 Answers   ANZ, Watt,

---

what is meant by cbct elr?

3 Answers  

---

Why we use cosine angle for calculating power factor not in sine angle ?

4 Answers  

---

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers  

---

---

Whether power factor should be high or low? Why?

0 Answers  

---

1 sq.mm alluminum cable hou much current caraing capacity

5 Answers  

---

what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?

0 Answers  

---

Is 3C x 2.5 Sqmm Cable can withstand 40Amp Starting current? If Yes then specify your ans.

2 Answers   NTPC,

---

Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.

0 Answers   BARC, Fedco, Qasco,

---

sir , what happen if we decrease ( approx 3 inch ) the lenth of shaft in 110KW Induction , three phase motor. actually a 110KW motor is couppled with star couplling to 120TR compressor. When we doing maintenance in compressor it is required to skid the motor backword and resulting dis- alightnment . so we want to change the tyre coupling in place of existing coupling. so it is required to cut off the rotor aprox 3 inch form driving side.

2 Answers  

---

HOW DEFINE THE IP FOR ELECTRICAL EQUIPMENT AND WHAT IS THE IP OF PANELS USING IN HAZARDOUS AREA ?

2 Answers  

---