Answer / bala_vlsi

first u finalized the connected loads and u will consider
diversity factor for individual loads . after this
calculation u will have some load in kw .
now u will convert to KVA
KW/ POWER FACTOR = KVA
Now you can select the suitable transformer for your
desiarable loads

documented proof that aluminium bus bars are better than aluminium cables

0 Answers  

---

why use only sf6 circuit breker in 400 kv sub station

5 Answers   BARC,

---

We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?

0 Answers   Bhel,

---

Describe how a salient pole / projecting pole rotor differs from a cylindrical rotor and state the application of each rotor respectively

3 Answers  

---

We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.

0 Answers   HAL,

---

LT cable fault checking instrument is available? where and how to get it.

2 Answers  

---

power generation unit kw/hr or kw/day ?? please answer me engr_kalam@yahoo.com

3 Answers  

---

what is saturation? what role it plays in operation of ct's,motors etc and how its affects the behaviour of the same.

1 Answers  

---

What is the basic rule for block diagram reduction technique?

0 Answers  

---

how to calculate relay rating for 50kw load

1 Answers   JNU,

---

In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification

1 Answers  

---

what was the function of the auxillary relay?

3 Answers  

---