IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TER

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN
OUTPUT (THAT MEANS TERMINAL SIDE OF THE INSRUMENTS) I,M
RECEIVING ONLY 6 VOLTS, WHAT IS THE REASON FOR THAT MUCH
VOLTAGE DROP?

Question Posted / deenatvm06

3 Answers
5057 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TERMINAL SIDE OF THE IN..

Answer / k.prakashchandra

If it is the output ,the instrument could be either a
potentiometer or a dc/dc converter.

Is This Answer Correct ?

2 Yes

0 No

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TERMINAL SIDE OF THE IN..

Answer / harsha

If the instrument is highly resistive material then there
is more voltage drop.

Is This Answer Correct ?

1 Yes

0 No

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TERMINAL SIDE OF THE IN..

Answer / mahesh ag

Any short circuit inside the instrument may also produce
low output voltage.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is meant by magnetic flow meter ? explain its working principle ?

1 Answers

10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL FAULTS IS ........

6 Answers SSC,

what is feeder?

2 Answers

how does PLCC work?...

1 Answers

what is relation between motor poles & motor current in 3 phase motor

1 Answers

Define the overload capacity of the motor?

0 Answers

What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?

0 Answers

In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???

0 Answers RRB,

You are of electrical field and you are going for software? Why

0 Answers

what is real power and reactive power?

3 Answers

i) in which cases should we go for neutral and where should we go for ground? ii) in domestic supply we are getting 230v a.c.and what is the amount of current?

2 Answers

who is ohm's and his law ?

1 Answers

For more Electrical Engineering Interview Questions Click Here