Answer / siva rao

Moulded case circuit breaker.its nothing but a MCB with
additional earth leakage protection.

Answer / shiva

MCCB: Moulded Case Circuit Breaker , These are using at
High rating currents from 63A to 1600A ,with short circuit
and earth leakage protection

Answer / jaimn

MCCB= MOULDED CASE CIRCUIT BRAKER

Answer / uday goud (hyd)

MOULDED CASE CIRCUIT BRAKER

Answer / vinod kumar

MCCB means moulded case circuit breaker IT MEANS THAT IT PROTECTS FROM HEAVY UNWANTED OR OVER CURRENTS . THE RANGE OF THIS IS 63A TO 3200A , I AGRRED WITH ANSWER 1 & 6 BUT AS MENTIONED IN 2 THE RANGE S NOT CORRECT.

Answer / rathis

It is a protective device......

Answer / saurabh bhardwaj (hathras)

It is basically type of how the circuit breaker operated at
sub stations
1.MOTOR CONTROLLED CIRCUIT BRAKER
2.MANUAL CONTROLLED CIRCUIT BRAKER

Answer / all interview.com

miniture current circuite breaker

how to calculate cable size in diffrent loads?

0 Answers   ABB, Sterling,

Why Ac Systems Are Preferred Over Dc Systems?

0 Answers   ABB,

th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.

0 Answers   HMC,

How to design the earth grid for lightning protection in an industry

2 Answers  

Which Kind of machines(in terms of poles) give the smoothest DC

0 Answers  

How to do the REF Stability test for power transformers in Site?

1 Answers   Escorts, Siemens,

in dc transmission the frequency pi is zero, then how it will transmit communication signal?

1 Answers  

why root three is used and how its comes in three phase power system?

1 Answers   IEEE,

What conditions are required for a transformer to operate at low frequencies ?

1 Answers  

What is the electrical difference between Earthing Switch (ES) and Maintenance Earthing Switch (MES)?

1 Answers  

Cb closed condition if there is a tcs fail whether cb will trip or not

0 Answers   AADC,

In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured after the resistor(4KOhm) which is open with negative.it shows 55V +ve when measured, also the actual positive source is 55V +ve .Because there is no voltage drop in open circuit. How can we identify whether this is the voltage which is series with the resistor or the DC source direct +ve.

1 Answers   GE,