Answer / haja bahurudeen m

Answer : A


Cisco Default LMI Type

Answer / guest

Answer: A

Local Management Interface (LMI) was developed in 1990. LMI
messages

provide information about the current DLCI values, the
global or local

significance of the DLCI value, and the status of virtual
circuits.

There are three types of LMI standards:

ANSI - Annex D defined by ANSI standard T1.617

ITU-T (Q.933A) - Annex A defined by Q933A

Cisco (default) - LMI defined by the gang of four

How do you get help on a command after you have received the % incomplete command response from a switch CLI? A. type "history" to review the prompt before the error B. enter a question mark to display all the console commands C. type help followed by the command to see command parameters D. reenter the command followed by a question mark to view keywords

1 Answers  

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

2 Answers  

---

How we put NIC in promiscuous mode when using MS windows, can any one tell me in detail

1 Answers   Cisco, IBM,

---

Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's

2 Answers  

---

What is collision?

0 Answers  

---

---

What command displays detail information about the OSPF interfaces, including the authentication method?

1 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Console E.) Trace

2 Answers  

---

Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.

1 Answers   Sutherland,

---

Of the following switching types, which one has the lowest latency? A.) Cut-through B.) Fragment Free C.) None D.) Store-and-forward

1 Answers  

---

Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!

5 Answers  

---

Explain why is udp lease favored when compared to tcp?

0 Answers  

---