When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---

the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected??

2 Answers   SoftTech,

---

On which layer does L2F, PPTP and L2TP operate?

0 Answers   CCIE,

---

Which statement about Ethernet switches is true? A. Symmetric switching allows connection between pods of unlike bandwidth and does not require memory buffering B. Memory Buffering is used to prevent a bottleneck when pods of different bandwidth are connected on a symmetric switch C. The latency can be reduced if the switch utilizes the store and forward method of switching store and forward is better for error detection D. The cut through method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address

1 Answers  

---

What will happen in OSPF, While a new highet priority DR joining in already running area.That area already having DR and BDR.

2 Answers   HCL,

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

1 Answers  

---

What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached

2 Answers  

---

Why we choose the router rather then L-3 Switch

8 Answers   Network Solutions, Wipro,

---

How can an Ethernet switch improve network performance? Choose three

2 Answers  

---

The ICMP (referred to in PFC 1700) is implemented by all TCP/IP hosts A. true B. false

1 Answers  

---

Identify the 2 commands that save the running-config to a TFTP server? A.) write running tftp B.) copy running network C.) copy running tftp D.) write network

3 Answers  

---