Answer / guest

Answer: C

You want to segment a network. The network is running SNA and Netbios. Which device should NOT be used to segment the network? A.) A store and forward switch. B.) A router. C.) A Catalyst 5000. D.) A cut-through switch. E.) A bridge.

1 Answers  

---

What is the different between console port and auxiliary port?

0 Answers  

---

What is the frame relay?

0 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

hi... i am a beginner to CCNA... i find it hard understandin collision domain n broadcast domain.. please don tell me the definition.. i read the definitions many times... i need a more detailed explanation... like whn i read the definition it sounds simple... but i don understand whn they say it like a hub has one collision domain and one broadcast domain... and if collisions happen inside collision domain... i am confused... please help me... :(

4 Answers  

---

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

---

What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

2 Answers  

---

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

2 Answers  

---

Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route

2 Answers  

---

What is the mesh network?

0 Answers  

---

You have a Frame Relay link on serial 1. Which command displays the Local Management Interface (LMI) data link connection identifier (DLCI) and bandwidth for that link? A. show interface serial1 B. show frame-felay serial1 C. show protocol frame-relay serial1 D. show serial1 encapsulation frame-relay

1 Answers  

---

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

4 Answers  

---