What is the size of hello packets in eigrep protocol?
No Answer is Posted For this Question
Be the First to Post Answer
Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack
What are the different types of network in ccna?
Wnat do you know about zenpeck
What s the formula for metric of ospf?
Which service uses telephone control messages and signals between the transfer points along the way to the called destination? A. Signaling System 7 (SS7) B. Time-division Multiplexing (TDM) C. X.25 D. Frame relay
what are the 3ree way for implementing vlan on cisco switches what is the layer hierarchy of the cisco what is the best place of implementing standard access list what is q stand for isdn these are the challanging question for me i am waiting for jitendera sinha answer(it is challenge for u i have seen lots of answer given by u )it is a challenge in the frendshipmode plz donot take other wise
as we know that isdn bri port come with either a u interface or some thing s/t interface what is the diffrenmce between them
Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
What is link aggregration?? How many types of protocol are used on that???
what is different between semi-managed and managed Switch ?