Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  

---

in which way the datas will transfer from one host to another host by using osi layer?

3 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

What are 10base5 ethernet lans?

0 Answers  

---

When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

2 Answers  

---

Mention what is bootp?

0 Answers  

---

What is the difference between rip and igrp?

0 Answers  

---

A ISDN BRI circuit can be described as a which of the following? A.) 3B channels B.) 2-64Kbps B channels and 1-16Kbps D channel C.) none of the above D.) 2-64Kbps B channels and 1-16Kbps C channel

1 Answers  

---

Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route

1 Answers  

---

What is the difference between the user mode and the privileged mode?

0 Answers  

---

Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 Answers  

---