Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP

1 Answers  

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

1 Answers  

---

What are the different memories that are used in a cisco router?

0 Answers  

---

Identify the true statement regarding subnetting? A.) Allows for more host address B.) Borrow bits from the network portion of the address C.) Allows for unlimited number of networks D.) Borrow bits from the host portion of the address

1 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

Hub in star topology or bus topology?

0 Answers  

---

If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2

1 Answers  

---

What is the beaconing?

0 Answers  

---

Which address or number is used to pass the data to the correct application? MAC Number IP address Port Number Segment Number

2 Answers  

---

The following commands were entered at the command prompt of a Cisco router. What do they accomplish? access-list 1000 deny 9e.1234.5678.1212 4 access-list 1000 permit -1 interface ethernet 0 ipx network 9e interface ethernet 1 ipx network 4a interface serial 0 ipx network 1 ipx output-sap-filter 1000 A. File server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0. B. All other SAP services, other than file server, from any source will be forwarded on S0. C. All other SAP services, other than print server, from any source will be forwarded on S0. D. Print server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0.

1 Answers  

---

Why OSI layers having 7 layers instead of one layer.

8 Answers   HCL,

---

Which cable called v.35?

0 Answers  

---