Answer / prashant patil

Bus coupler is used to connect two bus section in bus bar.
where as bus riser is used to rise lower the end of the bus
coupler circuit breaker to bus bar level. it also used to
mount bus bar PT & Protection CT on bus riser. There for it
used for three pourpose so need not requrid extra panel for
bus PT.

Answer / ahmed

Act as connector between MDBs and SMDBs by the blg in box
(tap off )
Used in high rating currents with low voltage drop it
contain from cupper tabs separated by insulation for
connector (RYPNE) There is many types and rating of bus
bare as per sit condition

why the transformer ratings in kva or mva?

4 Answers  

---

25 kva 3 phase dg how many current will take per phase , plssssssss reply me

3 Answers   Bharti,

---

Why derivative controller is not used in control systems?

0 Answers  

---

Why single core cable required bonding at double end.

1 Answers  

---

Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel

0 Answers   IOCL,

---

what types of load we get from the national grid? is this capacitive or inductive?

1 Answers  

---

why a pilot exciter is used in combination with the main exciter? why not only a main exciter is used for excitation to an alternator?

1 Answers   Electrical,

---

how the harmonic pluses take place in the flow of current

2 Answers  

---

How 3 phase invertor works?

0 Answers   Aero Ltd,

---

why CT output is always raetd 5.regardsof primery curre.

3 Answers   ABB, BARC,

---

How can we calculate the fault level of the distribution system knowing the percentage impedance of transformer & subsequent equipments.

14 Answers  

---

Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com

0 Answers  

---