Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between bus-coupler and bus-riser
- 2 Answers
- 44594 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant patil
Bus coupler is used to connect two bus section in bus bar.
where as bus riser is used to rise lower the end of the bus
coupler circuit breaker to bus bar level. it also used to
mount bus bar PT & Protection CT on bus riser. There for it
used for three pourpose so need not requrid extra panel for
bus PT.
| Is This Answer Correct ? | 53 Yes | 10 No |
Post New Answer View All Answers
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
Why 9KV surge arrester having 7.65KV of MCOV?
why the India electrical supply transmission loss is high when compare to us
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
What is the significance of integral controller and derivative controller in a pid controller?
What is meant by impedance? difference between high & low impedance ?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
can some one clearly explain why -48 volt DC use in telecom site????
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
send me all basic electrical question and answers
Is potential difference materials property ..? if yes tnen how.. explain brifly.
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
