what is difference b/w the solinoid volve and autodrain?
Answers were Sorted based on User's Feedback
Answer / dhirendra
both are same
drain valve will be oprate solenoid
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / faiyaz ahmad
solenoid valve is electro mechanically valve its work only two condition either NO/NC when it will be energize valve will be open and when it will be DE energize it will be close its consist of coil and plunger when it will energize plunger move toward and it will be flow
ecodrain valve is used to drain the waste water there are three types ecodrain 12/13/14/
its used in instrument air com pressure
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / priyank sharma neb alwar rajas
solenoid is a electropneumatic device which flow the air
according to coil charge & discharge command. that coil may
be 24 vDC or 230 VAC.
autodrain is the elctROMECHANIC DEVICE which is the
combination of solenoid valve & control card.in that
solenoid passes the water at the coil charging command.it
uses in air receivers for drain the water.
| Is This Answer Correct ? | 5 Yes | 6 No |
1.how can calibration temperature transmitter and flow transmitter? 2.
what is Pre- commissioning.
what is the difference between single and double compression cable gland
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
How is work 5/2 sov?
What does threshold mean? what does tolerance mean?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
I have 475 hart communicator. this is not support any new type of instruments such as tranmitter,fieldvue DVC6200.DVC 200 since i got point out need to upgrade . my questions is how can upgrade new instruments software in my 475 hart communicator. can any answerplease>?
How to calibrate radar lt type transmitter
what is maximum vaccume?
why we use only 4 to 20ma other than 0 to 16 ma
IS THEIR ANY AGEING EFFECT ON FLOW NOZZLE, ORIFICE, MANIFOLD, OR TRANSMITTER ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)