Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet?

Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet?

IF yes or NO Please provide me IEEE Std. for the same.

Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC,

Please help as soon as possible.

Question Posted / amithpatil831

0 Answers
2273 Views
Yokogawa, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

What is scale factor of proximitor & unit of the viabration.

2 Answers Sabic,

what is meant by Valve reversibility?

2 Answers

Explain why plc require in analog input 4-20amp & 0-10 volt?

0 Answers

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers

why using negative supply for bentley nevada vibration system ?

0 Answers

Can anyone send most commonly asked interview question in Oil & Gas industry

0 Answers

What is sensitivity of K type thermocouple? Is polarity important in thermocouple connections?

3 Answers Honeywell,

what is Pre- commissioning.

5 Answers Saipem, Takreer,

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers OPaL,

Give 2 application of quartz crystal used for process parameter measurement.

1 Answers ADMA OPCO,

WHY WE R NOT USING THE TURBINE FLOW METER IN THE STREAM SERVICE ? pl explain?

3 Answers

What is linearity of RTD over 0 to 200 degC?

1 Answers Honeywell,

For more Instrumentation Interview Questions Click Here