Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..

2 Answers  

---

what is auto transformer?

4 Answers  

---

This is about the recent problem that we have faced in our project site. We have 6/7.5 MVA. 66/11kV three phase star - star power transformer. The neutral was solidly connected to the earthing mat. But because of high resistance of earthing mat (130 ohm on LV and 180 ohm on HV), one day LV side neutral earthing conductor melted and we had a huge damage. Can any one plz tell me what might happen when we connect power transformer neutral to the earthing mat which has high resistance (>100 ohm ) ?????

2 Answers  

---

What is the difference between line drop and percentage line drop?

0 Answers   Suzlon,

---

Why ferranti effect occurred in leading p.f load?

1 Answers  

---

A dc motor running on dc drive whose input is 3ph AC what will happen if we change the phase sequence of dc drive for e.g (R Y B) is connect as R B Y, will the motor run as same as previously running before changing phase without any effect

4 Answers  

---

What type of pipe material G.I or M.S is used for sprinkler system?

2 Answers  

---

. The string effcy in AC sys is 80% Then for same power, the string effcy in dc sys is a) less than 80% b) 80% c) more than 80% d) zero

1 Answers   Engineers India Limited,

---

Why induction motors draws higher current during starting condition?

1 Answers  

---

What is Energy based relay coordination & time based relay co-ordination? In which type of distribution arrangement these methods are applicable?

1 Answers  

---

How many percent of power are not being registered if we bypass one side of the meter base terminal using #8 cu wire on 1-phase kwhr meter. 

1 Answers  

---

Is Indian railway uses 25000v ac or dc?

7 Answers  

---