Answer / m m chotrani

Yes we can measure interface level by purge method.you can
use two purges (sensors of ss pipe generally 1/4"NB).Now
for interface measurement two liquids of different
densities should be there. suppose the interphase takes
place between 300 and 450 mm height from the bottom of the
tank.now the interface be 50%. height difference (probe
distance is 150 mm. multiply 150 withe density of 1st
liquid say 0.8 gm/cc.which will be 120mm. and multiply 150
with the density of another liquid with the density say 1.2
gm/cc which is 180 mm.So your transmitter range is 120-180
mm of water column. calibrate the transmitter for this
range and connect both the probes to HP and LP connections
of transmitters

Answer / ikarous

No,its not possible
you can use the level displacement transmitter which acts
according to buoyancy law

what is the difference between cold loop and hot loop

2 Answers  

---

In thermocouple could we use the lug for termination or not,Thermocouple is any time,I am currently concerned with K type.please let me know if anybody know

4 Answers   Saudi Aramco Shell Refinery Company SASREF,

---

How would i calibrate a new commissioned flow transmitter???

3 Answers  

---

How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks

0 Answers   Siemens,

---

WHY WE R NOT USING THE TURBINE FLOW METER IN THE STREAM SERVICE ? pl explain?

3 Answers  

---

why do we use 4-20 ma current why cant o-20ma

6 Answers   Southwest Cheese,

---

what is power factor?

1 Answers  

---

What is scan time of PLC?

2 Answers   Gujarat Borosil,

---

what is the principle of vibration

3 Answers  

---

Describe how to use megger to measure the earth resistance and insulation resistance

0 Answers  

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---

1)how we calculate the drum level? and how we select the transmitter range?

3 Answers  

---