Answer / carl_ellis

What kind of feedback is used in DP cells?

In electronic DP transmitters there is no feedback. Field
sensors measure a physical phenomenon but do not use feedback.

Closed loop controllers use feedback (the process variable
reflecting the change in the controller's/final control
element output) and valve positioners use position feedback.

Carl Ellis
Measure First

What is the reverse action and direct action

2 Answers   Samsung,

---

How we can re-range the DP transmitter, range is -0.5 to 2.0bara. new range is -0.5 to 5 bar

2 Answers   Rosemount,

---

What is meant by calibration

5 Answers  

---

What is the cascade control system and where is use in power plant give the detail with block diagram

1 Answers  

---

what is the best method to measuring level in high pressure and temperture thank?

4 Answers  

---

Can anyone send most commonly asked interview question in Oil & Gas industry

0 Answers  

---

What is the minimum rating availalbe for weld neck orifice in market?

0 Answers   Jindal,

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---

if I did short to both AO connections, channel will burn or what? m sure in AI it will damage to channel. But what will happens in AO?

1 Answers  

---

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

---

What is the use of control cable?

0 Answers  

---

How I identify to solonied coil which is 24v or 230v In our lab.because there is no tag.

1 Answers   MRPL Mangalore Refinery and Petrochemicals Limited,

---