Answer / syed waseem,dubai petroleum,ua

A transmitter is a device which converts physical quantity
(eg:flow,pressure,temperature and level) into electrical.
i.e 4-20 ma universal standard.
Pressure tranmitter converts the pressure in a vessel or in
a pipeline into electrical quantity.
for eg: a pressure tranmitter range is 0-200psi.
at 0%-4ma-0psi.
25%-8ma-50psi.
50%-12ma-100psi.
75%-16ma-150psi.
100%-20ma-200psi.

why we are using boosters at glass furnace is there any other thing?

1 Answers   CGL,

---

how to know the URL and LRL for steam drum level and why the calibration range is in negative ?

1 Answers   JSW, Samsung,

---

why need 3 element system in power plant? if it is not there then what l happen?

5 Answers  

---

What Is Pre- Commissioning Package +what is DCS & ESD Pre- Commissioning for Instruments Please explain your answer on practical ground base

0 Answers  

---

A RANGE OF TRANSMITTER IS (0-400)B mm abs what is "B"?

1 Answers   HCL,

---

A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m. Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m. What will be the %error in measurement? how?

3 Answers   McCoy Engineering,

---

what is difference between wheatstone bridge, pirani gauge and strain gauge ??? explain its principle and working

4 Answers  

---

types of valves

3 Answers   Bindal Papers, Kuwait Oil Company,

---

in split range control system we are using two control valves,but we have only one positioner and one feed back link.so how we use this one feed back link for two control valves?

2 Answers  

---

For an Instrumentation Engineer, is there any effect on Instruments of safety zones like zone0, zone1, zone2. As an instrumentation Engineer, what we have to consider or remember while working in these areas.( zones 0,1,2).

1 Answers  

---

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers  

---

What is the absolute temperature

2 Answers  

---