is there any current flows in our body?
Answers were Sorted based on User's Feedback
Answer / engineering.force
all the sensations in the body are conducted to the brain
through electrial currents, the eyes convert picture form to
electrical signal, the ears convert the sound to electrical
signal and similarly the pain caused due to the bruises or
injury or wounds is also conveyed through the electrical
signals in the body. complex electrical network.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / ajay gautam
Yes , some amount of current is flowing in our body due to internal heat of our body. It can be proved practicaally.and i had also tried the test.
First sit a person on a chair in position of lose body and then round a towel and start to bit him from the back portion of the chair and attach a tester with his hand to check the current . As you bit him from backward then the tester attach with his body indicates current.
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the relation between size of the anteena and wavelenghth of radiated wave
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
I want to know what must the CT ratio be on a load of 300A is a 3PH nutral to earh installation?
What is mean by STUB protection?
How will be the single line diagram of series trip HT breaker? how it works?
a 3 phase slip ring induction motor is wound for 4 poles on stator and 6 poles on rotor; when 3 phase balanced voltage source at 50 hz is applied to motor it will run at a)1500rpm b)1000rpm c)750 rpm d)zero rpm
13 Answers Essar, PSPCL, PSTCL,
Why we are testing a tan delta test in transformer? which purpose conduting that test? and time priode test?
Is it mandatory statutory requirement of transformer oil filtration annualy despite oil is withstanding required dieelectrical strenth and all others parameters
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
0 Answers Bhel, TNEB Tamil Nadu Electricity Board,
Whether power factor should be high or low? Why?
Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV,20kV, 30kV?
how can we calculate that how much capacitor is needed for a system to increase the pf?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)