Answer / avd

Don't do it. A bad apple can spoil good apples too if kept
together. If you connect good and bad battery bank in
parallel, good battery bank will continuously dicharge in
bad battery bank. Hence there will always be circulating
current between two battery banks. This will make your good
batteries bad very soon.

Answer / aree dewan

yes but with this connection the voltage will be constant
bur current will increase.

Answer / ankush miglani 09718151073

M NOT SURE BT STILL GIVING MY OPINION.
I SAY YES COZ IF THE TWO BANKS ARE CONNECTED PARALALY THE
OUTPUT WILL BECOME SOMTHING CONSTANT THAN THE O/P OF ONLY
FAULTY BANK. AS THE QUANTITY INCREASED THE RATIO DECREASES.

what is ps impedance test

0 Answers  

---

Hi My Dear All Friends, There is one question it is widely used in Power Project's High Voltage Engineering. Question- What is the diffrence between Earth fault and Back up Earth Fault....???? . . . . . . Have A Good Day

1 Answers  

---

At 765Kv, I have seen the use of PT at line side for metering and CVT for protection, although as far as my knowledge is concern, PT at this voltage level will have huge loss and more cost as compared to CVT as CVT can also perform same function of Protection and Metering? So my question is why use PT and not CVT for metering and protection in order to reduce the cost.

1 Answers  

---

what happen if i change the polarity of ac when it is connected with motor

3 Answers  

---

How many speed of dg start motor for engine starting time

1 Answers  

---

Why are we not getting shock while touching a metal which is being welded?

1 Answers  

---

WHAT IS ND RELAY AND HOW DOES IT WORK?

2 Answers  

---

How to Convert horsepower to kva? what is the three phase formula? explain me if u can Example..i have 50Hp Moter how can i convert in kva tell me formula three phases Rehan Smileavail@msn.com

4 Answers   Bajaj,

---

What is over fluxing in transformer?

1 Answers  

---

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers  

---

when the size of the cable used for the ht voltage is 300sqmm then what is the size of the conductor of each phase

2 Answers  

---

What is the function of Harmonics filter, and how to calculate that rating of the energy saving?

1 Answers  

---