Answer / varsha

A relay is a device which detects the fault and supplies
the information to the breaker for circuit interruption

Answer / tanu

nd relay is non
directional
relay thats
allows fault
current to be
flow in both
directions.
It always
connected to the
source side. And
sends signal to
c.b. When fault
occur in its
range.

What is the value of 3 phase voltage?

8 Answers   RECPDCL,

---

Who is reputed manufacturer of TNC switch for ACB in India ?

3 Answers  

---

BRIEFELY EXPLAIN MEGGAR PRINCIPLE

2 Answers  

---

what does happen if generator frequency fall in running condition & what should require immediately

4 Answers  

---

What are the typical values of characteristic impedences of overhead line and underground cabel? Why there is so much variation?

1 Answers  

---

what is the difference between capacitive and resistive voltage divider?

0 Answers  

---

how to apply b license to c license in tneb

0 Answers   Billroth Hospitals,

---

Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.

0 Answers   ABB,

---

what is the effect of power factor of machines in starting current

0 Answers  

---

which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it

0 Answers  

---

the transient state stability limit of a system wherin power is transmitted throgh a double transmission line is (a)equal to steady state stability limit (b)more than its steady state stability limit (c)less than than its steady state stability limit (d)equal to its dynamic stability limit

1 Answers  

---

May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?

0 Answers  

---